SD-Latent-Interposer

SD-Latent-Interposer

A small neural network to provide interoperability between the latents generated by the different Stable Diffusion models.

I wanted to see if it was possible to pass latents generated by the new SDXL model directly into SDv1.5 models without decoding and re-encoding them using a VAE first.

Installation

To install it, simply clone this repo to your custom_nodes folder using the following command:

git clone https://github.com/city96/SD-Latent-Interposer custom_nodes/SD-Latent-Interposer

Alternatively, you can download the comfy_latent_interposer.py file to your ComfyUI/custom_nodes folder as well. You may need to install hfhub using the command pip install huggingface-hub inside your venv.

If you need the model weights for something else, they are hosted on HF under the same Apache2 license as the rest of the repo. The current files are in the "v4.0" subfolder.

Usage

Simply place it where you would normally place a VAE decode followed by a VAE encode. Set the denoise as appropirate to hide any artifacts while keeping the composition. See image below.

LATENT_INTERPOSER_V3 1_TEST

Without the interposer, the two latent spaces are incompatible:

LATENT_INTERPOSER_V3 1

Local models

The node pulls the required files from huggingface hub by default. You can create a models folder and place the models there if you have a flaky connection or prefer to use it completely offline. The custom node will prefer local files over HF when available. The path should be: ComfyUI/custom_nodes/SD-Latent-Interposer/models

Alternatively, just clone the entire HF repo to it:

git clone https://huggingface.co/city96/SD-Latent-Interposer custom_nodes/SD-Latent-Interposer/models

Supported Models

Model names:

code	name
v1	Stable Diffusion v1.x
xl	SDXL
v3	Stable Diffusion 3
fx	Flux.1
ca	Stable Cascade (Stage A/B)

Available models:

From	to v1	to xl	to v3	to fx	to ca
v1	-	v4.0	v4.0	No	No
xl	v4.0	-	v4.0	No	No
v3	v4.0	v4.0	-	No	No
fx	v4.0	v4.0	v4.0	-	No
ca	v4.0	v4.0	v4.0	No	-

Training

The training code initializes most training parameters from the provided config file. The dataset should be a single .bin file saved with torch.save for each latent version. The format should be [batch, channels, height, width] with the "batch" being as large as the dataset, ie 88000.

Interposer v4.0

The training code currently initializes two copies of the model, one in the target direction and one in the opposite. The losses are defined based on this.

• p_loss is the main criterion for the primary model.
• b_loss is the main criterion for the secondary one.
• r_loss is the output of the primary model back through the secondary model and checked against the source latent (basically a round trip through the two models).
• h_loss is the same as r_loss but for the secondary model.

All models were trained for 50000 steps with either batch size 128 (xl/v1) or 48 (cascade). The training was done locally on an RTX 3080 and a Tesla V100S.

LATENT_INTERPOSER_V4_LOSS

Older versions