【QWEN】OUTPAINT — v1.0

Use 【QWEN】OUTPAINT — v1.0 in ComfyUI to create Qwen outpainted and text-to-image images from a Qwen model and text prompt; it saves images and can optionally apply SeedVR2 tiled upscaling and embed generation parameters.

Load the model in ComfyUI, enter a prompt, and generate an image; SeedVR2 tiled upscaling can be toggled on or off, while the workflow embeds generation parameters in saved images.

Sugestão · não verificado

Inputs are a Qwen model and text prompt; the documented uses are outpainting and text-to-image generation.

Outputs are saved images with generation parameters embedded for online publishing and remixing.

Enable “Use Nodes V2 (Vue)” in ComfyUI Settings, refresh the interface, and then load the workflow; the instructions warn that display problems may occur if this is not enabled.

Sugestão · não verificado

Install ComfyUI-UmeAiRT-Toolkit through ComfyUI Manager by searching “UmeAiRT,” or use the UmeAiRT Auto-Installer; the auto version is described as downloading models automatically.

Sugestão · não verificado

Manual setup lists an fp8 or bf16 model in models\diffusion_models; qwen_2.5_vl_7b_fp8_scaled.safetensors in models\clip; Qwen-Image-InstantX-ControlNet-Inpainting.safetensors in models\controlnet; qwen_image_vae.safetensors in models\vae; and either Qwen-Image-Lightning-8steps-V

The listed model files also include RealESRGAN_x4plus.pth, qwen_image_fp8_e4m3fn.safetensors, wan_2.1_vae.safetensors, and Qwen_Image_Distill-Q5_K_S.gguf.

Listed node packs include comfyui_ultimatesdupscale, comfyui-aspect-ratio-crop-node, comfyui-image-saver, comfyui-kjnodes, comfyui-mxtoolkit, rgthree-comfy, was-node-suite-comfyui, and ComfyUI-GGUF.

Choose the base version for fp8 or bf16 models, or the GGUF version for Q8, Q5, or Q4 models.

Sugestão · não verificado

Use three LoRA slots with individual on/off toggles and strength controls; additional LoRA modules can also be connected.

Before installing, verify the model files and node packs for the version you choose: the setup notes name ComfyUI-UmeAiRT-Toolkit, while the listed requirements include additional files and packs.

Sugestão · não verificado

Check whether your chosen version is the base or GGUF route before placing files, because the listed model formats and folders differ.

Sugestão · não verificado