【FLUX】ControlNet — v6.1

This ComfyUI workflow, 【FLUX】 ControlNet — v6.1, is for FLUX image-to-image ControlNet generation: it takes an input image, written prompt, Flux.1 D model, and LoRA settings, then saves generated images with generation parameters embedded.

The workflow is described as an all-in-one ComfyUI setup with eight nodes.

The v6.1 summary says it adds an Openpose and HED workflow.

Inputs are an image, written prompt, FLUX model, and LoRA settings.

The output is a saved image with generation parameters embedded; SeedVR2 tiled upscaling can be toggled on or off.

Enable ComfyUI’s “Use Nodes V2 (Vue)” setting, refresh the page, and then load the workflow.

Install ComfyUI-UmeAiRT-Toolkit through ComfyUI Manager by searching “UmeAiRT,” or use the UmeAiRT Auto-Installer.

ComfyUI-UmeAiRT-Toolkit is the custom node named for this workflow.

Files named in the setup include flux1-dev-fp8.safetensors, flux1-dev-fp16.safetensors, clip_l.safetensors, ae.safetensors, Shakker-LabsFLUX1-dev-ControlNet-Union-Pro.safetensors, t5xxl_fp8_e4m3fn.safetensors, ViT-L-14-TEXT-detail-improved-hiT-GmP-TE-only-HF.safetensors, 4x_NMKD-

Other listed node packages are comfyui_controlnet_aux, comfyui_ultimatesdupscale, comfyui-image-saver, comfyui-kjnodes, comfyui-mxtoolkit, and rgthree-comfy; listed node names include BasicScheduler, Canny, DualCLIPLoader, DualCLIPLoaderGGUF, Image Comparer (rgthree), Image Saver

In the manual version, the listed files go in ComfyUI model folders; the auto version is described as downloading models automatically.

Each of the three LoRA slots has its own on/off switch and strength control, and additional LoRA modules can be connected.

Enable “Use Nodes V2 (Vue)” before loading; the description warns that display problems may occur if it is off.

Sugestão · não verificado

Before installing, check which model files and node names your chosen variant uses; the instructions describe both auto and manual variants and list multiple model and node names.

Sugestão · não verificado