【HiDream】INPAINT — v2.0

Use this HiDream workflow in ComfyUI to inpaint and run image-to-image generation from an input image, prompt, and HiDream model files; it saves generated images with their generation parameters embedded in metadata.

Built-in SeedVR2 tiled upscaling can be toggled on or off.

Provide an image, a prompt, and the required HiDream model files.

The workflow saves generated images with their generation parameters embedded in the metadata.

Enable ComfyUI’s “Use Nodes V2 (Vue)” setting, refresh the page, and then load the workflow; without it, the workflow may have display problems.

Install ComfyUI-UmeAiRT-Toolkit through ComfyUI Manager by searching “UmeAiRT,” or use the UmeAiRT Auto-Installer.

The workflow lists comfyui-umeairt-toolkit as a required custom node.

It lists HIDREAM/Dev as the checkpoint and seedvr2_ema_7b_sharp_fp8_e4m3fn_mixed_block35_fp16.safetensors as the upscaler.

Manual setup also lists ae.safetensors for ComfyUI\models\vae, plus clip_l_hidream.safetensors, clip_g_hidream.safetensors, t5xxl_fp8_e4m3fn_scaled.safetensors, and llama_3.1_8b_instruct_fp8_scaled.safetensors for ComfyUI\models\clip.

Three LoRA slots provide individual enable toggles and strength controls, with support for connecting additional LoRA modules.

For manual setup, the listed variants are base for 24 GB of VRAM, Q8_0 for 16 GB, and Q5_K_S for 12 GB.

Place hidream_i1_dev_fp8.safetensors in ComfyUI\models\diffusion_models, or place hidream-i1-dev-QX_K_S.gguf in ComfyUI\models\unet.

Before use, verify that comfyui-umeairt-toolkit, HIDREAM/Dev, and seedvr2_ema_7b_sharp_fp8_e4m3fn_mixed_block35_fp16.safetensors are available in your ComfyUI setup.

Vorschlag · nicht geprüft

For manual setup, verify the listed model filenames and ComfyUI folders before loading the workflow.

Vorschlag · nicht geprüft